Usb flash drive cryptex + 4 micro sd 3D for print
1733 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
by rwsmith123
80 mm long
36 mm wide over all
can make and use your own combo by slipping the rings o...ff
then back on to the inner rings
added 4 micro sd card slots to the usb hole.
added my own parts tray so u can swap and go
or add cash toys etc.
tight fit need to clean edges and slide in and out few times.
green arrow shows where u might need to trim to get end cap on
Wanhao
Printer:
Wanhao Duplicator i3 V2
Supports:
No
Resolution:
.2 high
Infill:
70
Notes:
tight fit need to clean... edges and side in and out few times
Designer
gummybear2233d model description
remix from USB Flash Drive Variable Cryptexby rwsmith123
80 mm long
36 mm wide over all
can make and use your own combo by slipping the rings o...ff
then back on to the inner rings
added 4 micro sd card slots to the usb hole.
added my own parts tray so u can swap and go
or add cash toys etc.
tight fit need to clean edges and slide in and out few times.
green arrow shows where u might need to trim to get end cap on
3d model print parameters
Printer brand:Wanhao
Printer:
Wanhao Duplicator i3 V2
Supports:
No
Resolution:
.2 high
Infill:
70
Notes:
tight fit need to clean... edges and side in and out few times
