Vampire bat 3D for print
842 Views 0 Likes 0 Downloads Download
Updated with lower resolution model files.
Night Bat Remix: http://www.thingiverse.com/thing:1092864
Ghost Bat Remix: http://www.thingiverse.com/thing:1095980
No
Supports:
Yes
Resolution:
250
Infill:
6%
Notes:
Best orientation for the model: From an upright position, rotate model 13...5 degrees backwards so that its ears point at a downward angle (shown in picture).
Printed on a Type A Machines 2014 Series 1 3D Printer
Printed with Real Black PLA from 3D Solutech
Printed with support, 55 degree overhang angle
Printed with a brim, 20 lines
250 microns (0.25 mm layer height)
330 mm Width (13 inches)
10h Print Time
0.8 mm Shell Thickness
6% Fill Density
80 mm/s Print Speed
0.4 mm Z hop when retracting
36.71 m of filament used
230C Print Temperature
Sliced with Cura
Modeled with Z Brush
Designer
YEG 3D Printing3d model description
Decorate your house with Vampire Bats this Halloween! With multiple holes along its spine, this model can be hung upside down, right side up, floating... flat, and many other orientations. All you need is fishing line and a push pin.Updated with lower resolution model files.
Night Bat Remix: http://www.thingiverse.com/thing:1092864
Ghost Bat Remix: http://www.thingiverse.com/thing:1095980
3d model print parameters
Rafts:No
Supports:
Yes
Resolution:
250
Infill:
6%
Notes:
Best orientation for the model: From an upright position, rotate model 13...5 degrees backwards so that its ears point at a downward angle (shown in picture).
Printed on a Type A Machines 2014 Series 1 3D Printer
Printed with Real Black PLA from 3D Solutech
Printed with support, 55 degree overhang angle
Printed with a brim, 20 lines
250 microns (0.25 mm layer height)
330 mm Width (13 inches)
10h Print Time
0.8 mm Shell Thickness
6% Fill Density
80 mm/s Print Speed
0.4 mm Z hop when retracting
36.71 m of filament used
230C Print Temperature
Sliced with Cura
Modeled with Z Brush
