Vase #673 3d model for 3d printers free

614 Views 0 Likes 0 Downloads Download

Designer

3d model description

This pen cup can be printed in vase mode or spiralize outer contour in cura, or printed in normal mode. You can uncheck spiralize outer contour to pri...nt in normal mode, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. Set walls to 1 or 2 or more for a more sturdy vase if not in vase mode. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% of the stl file at 72mm wide for X and Y and Z is 110mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...

NoTEs .....below

3d model print parameters

Printer brand:

Creality

Printer:

Ender 3

Rafts:
No

Supports:
No

Resolution:
0.2

Infill:
0

Filament brand:

Suntop

Fil...ament color:

silk green

Filament material:

pla

Notes:

The stl file IS hollow.....The vase does not have a bottom, but prints fine in vase mode. (see the photo)

DON'T just download and start printing, you will get a nice solid vase, great for a paper weight! Use 0 top layers, 0% infill if not printing in vase mode. I used a wall line width of .8 and a layer height of .2 other widths might work, I haven't tried them. The print should take approximately 1 hour 35 minutes at 50mm/s using vase mode.

Designed using Fusion 360