Vase #650 3D for print
10628 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Enjoy....
(Notes are below....;)
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
Tecbear
Fi...lament color:
rainbow
Filament material:
pla
Notes:
The stl file is solid.
Use 0 top layers, 0% infill if not printing in vase mode. Check your slicers view to make sure your vase is hollow. I used a wall line width of .8 and layer height of .2 other heights might work, I haven't tried them. The print should take approximately 5 hours using vase mode at 50mm/s.
...Designed using Fusion 360...
Designer
Steve Warren3d model description
This flower vase, for decorative purposes, can be printed in spiral vase mode or spiralize outer contour in cura. Or, print in normal mode, uncheck sp...iralize outer contour, set top layers to 0. Set infill to 0%. Bottom layers set to 3 or more. Set walls to1 or 2, or more, for a more sturdy vase. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% at 114mm wide and 165mm tall. It has not been tested for being watertight. It is for decorative purposes. If you make it, please post a photo, I'd like to see your print!Enjoy....
(Notes are below....;)
3d model print parameters
Printer brand:Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
Tecbear
Fi...lament color:
rainbow
Filament material:
pla
Notes:
The stl file is solid.
Use 0 top layers, 0% infill if not printing in vase mode. Check your slicers view to make sure your vase is hollow. I used a wall line width of .8 and layer height of .2 other heights might work, I haven't tried them. The print should take approximately 5 hours using vase mode at 50mm/s.
...Designed using Fusion 360...
