This vase can be printed in vase mode or spiralize outer contour in cura, or printed in normal mode. You can uncheck spiralize outer contour for norma...l mode, set top layers to 0, set infill to 0%. Bottom layers set to 3 or more. Set walls to 1 or 2 or more for a more sturdy vase if not in vase mode. Can be scaled to fit your needs. The vase in the photo shows vase not scaled at 100% of the stl file at 84mm wide for X and Y and Z is 110mm tall. It has not been tested for being watertight and probably isn't printed in vase mode. If you make it, please post a photo, I'd like to see your print!
Enjoy...
(Notes below...... :)
3d model print parameters
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
0
Filament brand:
Suntop
Fil...ament color:
carbon fiber
Filament material:
pla
Notes:
Using 'spiralize' will automatically make 1 wall and 0 top layers, no matter if you have 2 or more walls checked. You will need to put in 1 or more bottom layers. Once you plug in the numbers check the 'layer view' to make sure the vase is hollow and has a bottom.
The stl file is not hollow. Don't just blindly download and start printing, you will get a nice solid vase, great for a paper weight but not a pencil holder! Use 0 top layers, 0% infill if not printing in vase mode. I used a wall line width of .8 and a layer height of .2, other widths might work, I haven't tried them. The print should take approximately 1 hours 20 minutes at 40mm/s using vase mode.