X525 quadcopter foot 3D for print
826 Views 0 Likes 0 Downloads Download
Attribution:
http://www.thingiverse.com/thing:40475 - Original feet
http://www.thingi...verse.com/thing:10541 - pins
Foot for quadcopters made from 13mm square tubing with a predrilled hole on the side of the tubing for mounting a foot.
Meant for my Hobbyking X525.
The v2 version is stronger, mine (printed in ABS) survived a few hard landings without damage. Uses same pin as original.
v2 also have indentations for the motor mount bolts as present on the X525.
Pin fits in hole at the bottom of the foot.
- 2 x foot (per arm)...
Designer
MoHaG3d model description
A printable replacement foot for the X525 frame by Hobbyking.Attribution:
http://www.thingiverse.com/thing:40475 - Original feet
http://www.thingi...verse.com/thing:10541 - pins
Foot for quadcopters made from 13mm square tubing with a predrilled hole on the side of the tubing for mounting a foot.
Meant for my Hobbyking X525.
The v2 version is stronger, mine (printed in ABS) survived a few hard landings without damage. Uses same pin as original.
v2 also have indentations for the motor mount bolts as present on the X525.
Pin fits in hole at the bottom of the foot.
3d model print parameters
- 1 pin (per arm)- 2 x foot (per arm)...
