Volantex ranger ex / quanum observer wings top plate camera mount 3D for print
1016 Views 0 Likes 0 Downloads Download
This is a plate that goes over the wings securing them to fuselage. I slightly mod...ified design trying to reinforce it as 3D printed part will be weaker than original. Where level should be I have re-purposed this for camera mount, using 1/4" BSW 1/2" long screw.
I would suggest printing this in resistant filament (nylon, taulman alloy910). Also I think it is good to use wide washers under screws to spread out stress as evenly as possible.
Designer
hedeon3d model description
This is a plate that goes over the wings securing them to fuselageThis is a plate that goes over the wings securing them to fuselage. I slightly mod...ified design trying to reinforce it as 3D printed part will be weaker than original. Where level should be I have re-purposed this for camera mount, using 1/4" BSW 1/2" long screw.
I would suggest printing this in resistant filament (nylon, taulman alloy910). Also I think it is good to use wide washers under screws to spread out stress as evenly as possible.
