This is a pot i created for my mom. She wanted something looking like a Weaved Pot, so i designed this.
To print this i used the following settings: ...
Layer Height: 0.2mm
Shell Tickness: 0.6mm
Spiralize
Bottom of 2mm
0% infill
Speed 50mm/s
On a Ultimaker 2 with these settings at full size (190mm x 100mm x 140mm) it takes 10h to print and uses about 24m of filaments.
The second part can be printed and glued to reinforce the part where it is fixed on the wall.
Top and Bottom of 0.8mm Shell of 0.8mm and infill of 30%