Wizard secret puzzle box 3D for print
3759 Views 2 Likes 1 Downloads Download the piece here from 3dforprint
https://www.thingiverse.com/thing:3109214
Secret Harry Potter Box by -Josh-. His model isn't available anymore, so I have created... this as a remix of the model he remixed.
Prusa
Printer:
i3 MK3 MMU 2
Rafts:
No
Supports:
No
Resolution:
0.2
Filament_brand:
ProtoPasta and Fillamentum
F...ilament_material:
PLA
Notes:
For general print and assembly see the thing I remixed. For the 7 colors on the lid I added M601 and M602 commands to the gcode in the middle of the print to switch out the yellow for red and blue for green half way though the print. If you are using firmware 3.5.0 on a Prusa printer the M601 has a bug in it that results in an infinite pause resume loop. You can either roll back to the previous firmware version or use the firmware that I forked with a workaround for this bug found at https://github.com/TheHammockGuy/Prusa-Firmware Be sure to check "Detect thin walls" in Slic3r under Layers and Perimeters. Some of the features such as the snake's fangs and raven's legs are only 0.4mm wide so you need the slicer to be able to draw single line with sections or those features will be left out or lose definition.
Designer
thehammockguy3d model description
This is a remix ofhttps://www.thingiverse.com/thing:3109214
Secret Harry Potter Box by -Josh-. His model isn't available anymore, so I have created... this as a remix of the model he remixed.
3d model print parameters
Printer brand:Prusa
Printer:
i3 MK3 MMU 2
Rafts:
No
Supports:
No
Resolution:
0.2
Filament_brand:
ProtoPasta and Fillamentum
F...ilament_material:
PLA
Notes:
For general print and assembly see the thing I remixed. For the 7 colors on the lid I added M601 and M602 commands to the gcode in the middle of the print to switch out the yellow for red and blue for green half way though the print. If you are using firmware 3.5.0 on a Prusa printer the M601 has a bug in it that results in an infinite pause resume loop. You can either roll back to the previous firmware version or use the firmware that I forked with a workaround for this bug found at https://github.com/TheHammockGuy/Prusa-Firmware Be sure to check "Detect thin walls" in Slic3r under Layers and Perimeters. Some of the features such as the snake's fangs and raven's legs are only 0.4mm wide so you need the slicer to be able to draw single line with sections or those features will be left out or lose definition.
