Calvin and Hobbes, from the comic strip by Bill Watterson.
The comic strip Calvin and Hobbes follows the humorous antics of Calvin, a precocious, mis...chievous and adventurous six-year-old boy, and Hobbes, his sardonic stuffed tiger.
The full model is built using individual models of Calvin and Hobbes, therefore I created three separate Cults3D uploads:
For the final build using the individual Calvin and Hobbes models see: https://cults3d.com/en/various/calvin-and-hobbes (this upload)
For the Calvin model see: https://cults3d.com/en/various/calvin
For the Hobbes model see: https://cults3d.com/en/various/hobbes
No supports are required. If you have the right filament colors, no painting is needed.
The fully completed model is 250mm tall after assembly.
Enjoy!
3d model print parameters
Print Settings
Printer:
FlashForge Creator X
Rafts:No
Supports: No
Resolution:.2mm
Infill:10%
Notes: I used 3 bottom layers and 5 top layers
B...uilding the model
Colors (there are no multiple printed pieces)
Brown: log
Printing and assembly tips
1-No supports are required.
2-Be sure to use at least five top layers for the log for a clean finish.
Assembly tips:
-Build the Calvin model and Hobbes model using the Cults3D links provided in the introduction.
-The diagram in the pictures section will help in assembling the model and is quite straightforward.
-The model is meant to be glued together.