Archery target pen holder 3D for print

Designer

anders644pi

3d model description

I wanted to make a fun and creative pen holder, and this is what I came up with. A pen holder shaped like an archery target.

It works by pressing t...he pens through the holes in the base, and because it's only one layer thick (.2mm), it flexes and holds tightly around the pens.

You assemble it as shown in the gif on the bottom of this page. You do need a small strew and nut to mount the base onto the stand. But you basically screw the base and stand together, then fit together the rings on the base, and set the leg in place, by punching the pin into the hole in the stand.

PLEASE NOTE: YOU DO NEED TO STICK IT TO THE TABLE SOMEHOW, TO KEEP IT FROM FALLING OVER.

This is just my attempt on this 'technique', so fell free to improve on my design. But I hope you like it.

And if you like what you see, follow me on ​Instagram and ​Twitter (@Anders644PI) to keep up with what I make.​ My Insta:
https://www.instagram.com/anders644pi/
Read more

3d model print parameters

Printer:
PrimaCreator P120

Rafts:
Doesn't Matter

Supports:
No

Resolution:
0.2

Infill:
20-30%

Notes:
All pieces print flat on the ...bed, optimized for 3D-printing.
Exploding GIF Animation
Read more

Tags

Archery Archery target Koffie Office Pen Pencil Pencil holder Pen holder Target Target holder Useful

License

CC Atribution