Bag clip hinge tütenclip scharnier 3D for print
1773 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
It will be printed in one piece. PLA 0,15 Layer
with support Only board.
good is also 100% infill
1. not too hot prin...t, always retraction, Lift 0,08
2. when the hinge glued, then minus extrusion multiplier!
I wish you success
update 1: not so tight
Designer
Norbert3d model description
for closing with hingeIt will be printed in one piece. PLA 0,15 Layer
with support Only board.
good is also 100% infill
1. not too hot prin...t, always retraction, Lift 0,08
2. when the hinge glued, then minus extrusion multiplier!
I wish you success
update 1: not so tight
