Dji phatom - new legs - support for carbon tubes 3D for print
1347 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
These mounts allow you to repla...ce your DJI Phantom's legs with carbon fiber tubes. There is a fifth "leg" which holds the compass where it should be. The carbon tubes are 3mm in diameter and can be found in DYI shops and on the net (e.g. dx.com).
The mounts are designed to allow you to simply switch your existing legs with the new supports. You can reuse your existing screws. I used some epoxy glue to ensure that the carbon fiber tubes stay in place.
- Carbon fiber tubes, e.g. http://www.dx.com/p/9imod-carbon-fiber-electric-helicopter-training-gear-kit-for-...450-400-yellow-196927#.U5Hijyjm440
Designer
ClosedCircuit3d model description
Replace your DJI Phantom's legs with carbon tubes. There is a fifth "leg" which holds the compass where it should be.These mounts allow you to repla...ce your DJI Phantom's legs with carbon fiber tubes. There is a fifth "leg" which holds the compass where it should be. The carbon tubes are 3mm in diameter and can be found in DYI shops and on the net (e.g. dx.com).
The mounts are designed to allow you to simply switch your existing legs with the new supports. You can reuse your existing screws. I used some epoxy glue to ensure that the carbon fiber tubes stay in place.
3d model print parameters
- Reuse your existing DJI Phantom screws- Carbon fiber tubes, e.g. http://www.dx.com/p/9imod-carbon-fiber-electric-helicopter-training-gear-kit-for-...450-400-yellow-196927#.U5Hijyjm440
![Front damper bridge [Reely Rhino]](https://www.3dforprint.com/modelos/4107/front-damper-bridge-reely-rhino1_medium.jpg)
