Galaxy s4 tripod mount 3D for print
2023 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
The example was printed in P...LA on an Ultimaker 2 at 0.1 mm layer height.
1. Glue or epoxy a 1/4-20 nut in the recess of the base.
2. Place screw through top piece and thread the insert onto the screw.
3. Add a little glue to the insert and use the top piece to push the insert into the base as far as it will go. Remove the top piece as the glue dries so it does not get stuck.
4. When the glue is dry, thread the parts back together with the screw.
This project was inspired by http://www.thingiverse.com/thing:293679. I liked the design but I wasn't crazy about the rubber band so I used a thumb screw to hold everything together.
Designer
entomophile3d model description
This is an adjustable tripod mount for my Galaxy S4 with a case. It will fit any phone up to 12 mm thick and 90 mm wide.The example was printed in P...LA on an Ultimaker 2 at 0.1 mm layer height.
1. Glue or epoxy a 1/4-20 nut in the recess of the base.
2. Place screw through top piece and thread the insert onto the screw.
3. Add a little glue to the insert and use the top piece to push the insert into the base as far as it will go. Remove the top piece as the glue dries so it does not get stuck.
4. When the glue is dry, thread the parts back together with the screw.
This project was inspired by http://www.thingiverse.com/thing:293679. I liked the design but I wasn't crazy about the rubber band so I used a thumb screw to hold everything together.
