Intel kaby lake delid tool 3D for print
1998 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
This is the Kaby Lake Version of my simple delid tool.
Th...anks to "Stullen Andi" for sharing the CPU dimension source :)
This Version is BETA,
I dont have a Kaby Lake CPU therefore it would be great if someone can print, test it and give feedback if it will fit
This tool should also work with Skylake/Devilcanyon/Haswell CPUs as Kaby only has two additional noses.
* print both parts,
* put some sort of rubber or foam on the inner bottom of the base.
* put the CPU into the CPU-holder with the long PCB part looking over the end of the tray.
* then put it in your vice and close it slowly carefully (giving the glue time to release).
For enough strengh print at least with 3 perimeters and 30% infill !
USE AT YOUR OWN RISK !!!
* Only for CPUs who are glued and with thermal-paste, not for soldered CPU`s
Donation: paypal.me/chriyoumagine
A vice. - do NOT use a screw clamp (c-clamp) or a hammer !
a 3D printer that can print very exact, the dimensions ...are very tight to ensure that the cpu won`t jump out while pressing.
From the responses until now it seems that the glue of the Kabylake cpu`S may be a little bit stronger, so its strongly recommended to print with high-impact material like PLA at 0,1mm layerheight or less and very high infill !
Designer
Chri3d model description
A simple delid tool that for chopping Intel Kabylake and Skylake/Devilcanyon/Haswell CPUThis is the Kaby Lake Version of my simple delid tool.
Th...anks to "Stullen Andi" for sharing the CPU dimension source :)
This Version is BETA,
I dont have a Kaby Lake CPU therefore it would be great if someone can print, test it and give feedback if it will fit
This tool should also work with Skylake/Devilcanyon/Haswell CPUs as Kaby only has two additional noses.
* print both parts,
* put some sort of rubber or foam on the inner bottom of the base.
* put the CPU into the CPU-holder with the long PCB part looking over the end of the tray.
* then put it in your vice and close it slowly carefully (giving the glue time to release).
For enough strengh print at least with 3 perimeters and 30% infill !
USE AT YOUR OWN RISK !!!
* Only for CPUs who are glued and with thermal-paste, not for soldered CPU`s
Donation: paypal.me/chriyoumagine
3d model print parameters
Some sort of thin foam/rubberA vice. - do NOT use a screw clamp (c-clamp) or a hammer !
a 3D printer that can print very exact, the dimensions ...are very tight to ensure that the cpu won`t jump out while pressing.
From the responses until now it seems that the glue of the Kabylake cpu`S may be a little bit stronger, so its strongly recommended to print with high-impact material like PLA at 0,1mm layerheight or less and very high infill !
