Kordran conflict - demo miniature 2 3D for print
1059 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Here you can download the Captious Trooper demo miniature unit from the 3D printable strategy g...ame "Kordran Conflict" launching on Kickstarter.
For more information about the game and all the 3D printable pieces visit:
http://bit.ly/KordraCults3d
Print the 3 separate parts and combine to make your multi-color miniature!
The assembled model is 60mm tall.
Enjoy, and don't forget to post your makes!
Notes:
This model was created by the very talented Fotis Mint ( https://www.patreon.com/FotisMint ) which I split into parts for multi-color printing for the game.
Two versions of the model are supplied: a full one piece version and a separate two piece version.
Unlike most of my models, this model does need some supports.
Printing suggestions:
-Use your slicers 'fine or detailed' settings, typically .1mm layer height.
-Support overhang can typically be set to 80% (or 10% depending on your slicer).
-The bottom part does not need a raft or brim.
-The top part may need a brim depending on your printer.
Designer
REDDADSTEVE3d model description
Kordran Conflict - Demo Miniature by Plastic Alchemy.Here you can download the Captious Trooper demo miniature unit from the 3D printable strategy g...ame "Kordran Conflict" launching on Kickstarter.
For more information about the game and all the 3D printable pieces visit:
http://bit.ly/KordraCults3d
Print the 3 separate parts and combine to make your multi-color miniature!
The assembled model is 60mm tall.
Enjoy, and don't forget to post your makes!
Notes:
This model was created by the very talented Fotis Mint ( https://www.patreon.com/FotisMint ) which I split into parts for multi-color printing for the game.
Two versions of the model are supplied: a full one piece version and a separate two piece version.
Unlike most of my models, this model does need some supports.
Printing suggestions:
-Use your slicers 'fine or detailed' settings, typically .1mm layer height.
-Support overhang can typically be set to 80% (or 10% depending on your slicer).
-The bottom part does not need a raft or brim.
-The top part may need a brim depending on your printer.
