New z endstop/limit location for calibration a-la um2 on umo+ 3D for print
1608 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
V2 Didn't work but this last version works quite nicely.
This moves the Z stop from ...the top to the bottom, downside you lost 1cm of Z print area, no biggie for me, but it's the best I could do without cutting the UMO+ frame.
With this the idea it's to be able to reset the Z0 like UM2 and probably make a Calibration routine via Ulticontroller (not hard at all to do).
In progress, but working:
https://ultimaker.com/en/community/22120-idea-new-location-for-z-limit-on-umo
x2 M3 nuts for the endstop printed part
x2 M3 16-20mm To install the printed part
- It's a working progress. The Code... needed to make it work it's on the post.
Designer
Neotko / Sugarpop!3d model description
New Z endstop/limit location for calibration a-la UM2 on UMO+V2 Didn't work but this last version works quite nicely.
This moves the Z stop from ...the top to the bottom, downside you lost 1cm of Z print area, no biggie for me, but it's the best I could do without cutting the UMO+ frame.
With this the idea it's to be able to reset the Z0 like UM2 and probably make a Calibration routine via Ulticontroller (not hard at all to do).
In progress, but working:
https://ultimaker.com/en/community/22120-idea-new-location-for-z-limit-on-umo
3d model print parameters
x2 M3 10-16mm for the Endstopx2 M3 nuts for the endstop printed part
x2 M3 16-20mm To install the printed part
- It's a working progress. The Code... needed to make it work it's on the post.
