Notepad inbox 3D for print
1821 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
A notepad holder that serves as a... kind of inbox with a "you've got mail" flag that flips up when the lid is lifted.
It's a far from elegant, a pretty rough design mainly for my own use but serves its purpose well enough!
The pen holder is not very secure, you could add a conical shaped holder at the bottom to improve this but I've just used some blu-tak which does the trick.
You may need to slightly widen the flag hole to loosen the fit if it's overly tight.
I printed the base/enclosure with supports, but it might be possible to avoid them if your printer is particularly good with bridging. Cura's generated supports weren't too difficult to remove in my case.
Designer
zeiphon3d model description
A notepad holder that serves as a kind of inbox with a "you've got mail" flag that flips up when the lid is lifted.A notepad holder that serves as a... kind of inbox with a "you've got mail" flag that flips up when the lid is lifted.
It's a far from elegant, a pretty rough design mainly for my own use but serves its purpose well enough!
The pen holder is not very secure, you could add a conical shaped holder at the bottom to improve this but I've just used some blu-tak which does the trick.
You may need to slightly widen the flag hole to loosen the fit if it's overly tight.
I printed the base/enclosure with supports, but it might be possible to avoid them if your printer is particularly good with bridging. Cura's generated supports weren't too difficult to remove in my case.
