Ratcheting cable clamp 3D for print
1274 Views 0 Likes 0 Downloads Download
I printed in abs at 20% rectilinear infill but I set every 5th l...ayer to print solid for added rigidity.
Be aware that one of the parts is oriented upside down in the model, so if you print it as provided then you are trying to make a cantilever over air. Just remember to flip the part!
Hardware Required:
(1) #8 x .75" long bolt
(1) #8 nylock nut
OR You could probably substitute a Zip-tie for the bolt...
Designer
Michael3d model description
This is a simple clamp for holding bundles of wires, cables, or even pneumatic hose.I printed in abs at 20% rectilinear infill but I set every 5th l...ayer to print solid for added rigidity.
Be aware that one of the parts is oriented upside down in the model, so if you print it as provided then you are trying to make a cantilever over air. Just remember to flip the part!
3d model print parameters
Materials and methodsHardware Required:
(1) #8 x .75" long bolt
(1) #8 nylock nut
OR You could probably substitute a Zip-tie for the bolt...
