Um2 dual nozzle fan shroud 3D for print
4657 Views 2 Likes 0 Downloads Download the piece here from 3dforprint
Single Nozzle Version found here: https://www.youmagine.com/designs/um2-dual-fa...n-shroud
Disscussion about the fan shroud is found here:http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188
Please place comments in the discussion
Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.
Spacers are required to stop the hot end securing screws from hitting the shroud.
Make sure your temps arnt to high so overhangs are clean and the fit is correct. Can be printed with no infill.
Designer
Labern3d model description
Labern's Dual Fan Shroud For Original and Olsson Heaters Block SetupsSingle Nozzle Version found here: https://www.youmagine.com/designs/um2-dual-fa...n-shroud
Disscussion about the fan shroud is found here:http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188
Please place comments in the discussion
Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.
Spacers are required to stop the hot end securing screws from hitting the shroud.
Make sure your temps arnt to high so overhangs are clean and the fit is correct. Can be printed with no infill.
